NEWERA - CUSTOM PILLOW BALL REAR LINKS.

[Miguel - Newera]

We've had a batch of these lower tie rods and lateral rod specially commissioned for our cars and have a few sets remaining...

These are VERY heavy duty. The larger pillow ball bearings are much more resistant to wear than smaller ones, since they will spread loads more evenly. Construction is all stainless steel too. Note we haven't made upper ones, as that's where noise usually comes from when fitting a full set. With these fitted, the rear end becomes much more finely controllable for sliding. Note that by increasing the length of lower rods, this decreases grip also.

These are NOT available elsewhere, they've been developed and made to special design by an MSC and D1 Street Legal racer in Japan just for us.
Hurry though, our regular AE86 customers are reserving these fast, so they'll be gone very soon.

PM us if you have serious interest in reserving the last set.

[robokill]

lenght and price of the lateral rod shipped to nl plz.

I assume its shorter than the orginal one ?

[Jan Pedersen]

Price on the lateral bar shipped to Denmark

[Miguel - Newera]

Next time my car's on a lift for service work I'll get some decent pictures of these babies in place.

Just one last set left now, but we'll be commissioning another set if there's sufficient demand from serious people.

From centre of each pillowball 78cm.
PM's Sent

[delazy]

look like an awesome product.....

if only i hadnt just purchased some australian made ones

[V-t-e-c]

i shall be on to you in the future for some parts