Filters for ITB BT 20V
02-01-2009, 02:54 AM
Post: #3
 
1 x BASE PLATE BLANK ALLOY (ITG-9JC40)
1 x ITG FILTER JC40-100 (ITG-JC40-100) or ITG-JC40-65
1 x ITG FILTER DUST SPRAY (ITG-JDR1)


"

Fitting advice

Selection of the filter element depends on the amount of
room available.
ITG recommend fitting the tallest element possible, though
a gap of 1/2” (13mm) average must be left over the top of
the filter for air to circulate.
If using ram pipes, there must be an absolute minimum gap
of 3/4” (19mm) or preferably 11/4” (32mm) between the end
of the pipe and the underside
of the top of the filter.

"
Find all posts by this user


Messages In This Thread
Filters for ITB BT 20V - gjuro - 01-09-2009, 11:34 PM
[] - assassin10000 - 01-31-2009, 06:55 PM
[] - isac - 02-01-2009 02:54 AM
[] - Lajoosh - 03-15-2010, 11:10 PM
[] - boo50 - 07-13-2010, 04:23 PM
[] - [Walaki]D`Lair - 07-13-2010, 10:01 PM
[] - Akis308 - 07-15-2010, 02:30 PM

Possibly Related Threads...
Thread Author Replies Views Last Post
  4A-GE 20V ITB bolt patterns kjb 7 11,731 02-27-2016 01:23 PM
Last Post: kjb
  How to install 20V ITB on 16V head Mr.komp 7 11,598 12-28-2015 05:35 PM
Last Post: pack
  Machining Pistons to run 20v head... And FCR's on a 20v? PazzaAE86 2 5,049 09-15-2013 01:08 AM
Last Post: jondee86
  20v itb inlet manifolds totta Crolla 24 26,136 12-14-2012 12:21 PM
Last Post: Bean
  4AGE 20v ITB vacuum instructions on Intecracing.com JAVResistance 17 33,619 05-07-2011 05:50 AM
Last Post: jondee86

Forum Jump:


User(s) browsing this thread: 6 Guest(s)

Contact Us | AEU86 | Return to Top | Return to Content | Lite (Archive) Mode | RSS Syndication