|
T50 Transmission Bell Housing
|
|
01-05-2010, 04:14 PM
Post: #2
|
|||
|
|||
|
Nopes, they will not fit sadly. You have to find an A series bellhousing.
Then you have problem no.2. Bellhousing mount on the tranny side is different between T and A series T50s, so the output bearings will not fit. Have to machine a spacer to mount it and mix and match some parts. Also, the extension housing (with the shifter) is in a different location between AE86 and TA22/TE27. So you will need one if mounting in an AE86. Finally the output axle has a different number of splines. So you will need to have a driveshaft made if used in a AE86. Ideally: just use a 4AGE t50 if you are using a AE86/TE7X series chassis. If not, then I can probably find some more detailed links for you. A wheel to steer the front of the car A pedal to steer the rear |
|||
|
|
« Next Oldest | Next Newest »
|
| Messages In This Thread |
|
T50 Transmission Bell Housing - DRFT - 01-05-2010, 03:31 PM
[] - NoHachi - 01-05-2010 04:14 PM
[] - kitcarfreak - 01-09-2010, 12:00 PM
|
| Possibly Related Threads... | |||||
| Thread | Author | Replies | Views | Last Post | |
| Gearbox mount and transmission mount | gh0st | 9 | 3,589 |
05-08-2022 03:28 PM Last Post: totta Crolla |
|
| T50 gearbox | totta Crolla | 3 | 2,529 |
02-25-2022 02:35 PM Last Post: Project D |
|
| T50 TRD gearset | DidiDex | 7 | 9,097 |
09-12-2019 07:36 PM Last Post: DidiDex |
|
| 20v swap bell housing | izanagi | 2 | 4,206 |
12-15-2016 01:12 PM Last Post: pack |
|
| 4A-GE bellhousing on a 20 spline T50 | The Doctor | 2 | 7,033 |
09-30-2016 03:38 PM Last Post: The Doctor |
|
User(s) browsing this thread: 11 Guest(s)