|
Fitting a TRD/CBY N2 front lip
|
|
03-29-2011, 01:01 PM
Post: #4
|
|||
|
|||
|
i know your problem, yes you will have to cut slots out of your bumper to allow duct to pass. if you dont want to cut your bumper you could cut the duct back so it passes the bumper bottom. If you dont do either of these the lip will point downwards. I didnt get mine from mcnsport but mine is 10/20mm too big as well but when you actually start fitting it, it will come in also you can fit a longer bumper support bar and push the bumper corners out to meet it. hope that helps
|
|||
|
|
« Next Oldest | Next Newest »
|
| Messages In This Thread |
|
Fitting a TRD/CBY N2 front lip - Jimmi The Kid - 03-23-2011, 09:59 PM
[] - Jimmi The Kid - 03-24-2011, 07:57 PM
[] - Maurice - 03-29-2011 01:01 PM
[] - Jimmi The Kid - 03-29-2011, 07:32 PM
[] - Jimmi The Kid - 03-30-2011, 07:29 PM
[] - Jimmi The Kid - 03-30-2011, 08:34 PM
|
| Possibly Related Threads... | |||||
| Thread | Author | Replies | Views | Last Post | |
| Fitting Air Con (No PS) to LHD AE86 | pack | 7 | 4,161 |
01-07-2024 11:36 AM Last Post: CCB |
|
| Fitting Fibreglass Kouki Lip? | chrisae86 | 3 | 2,104 |
02-25-2022 08:14 PM Last Post: chrisae86 |
|
| Fitting driftworks CS2 coilovers | bozu | 2 | 4,690 |
05-30-2017 10:50 AM Last Post: bozu |
|
| goodridge SS brake lines fitting doubts | wouter86 | 17 | 17,260 |
04-30-2014 06:33 PM Last Post: wouter86 |
|
| Flywheel fitting | totta Crolla | 11 | 12,829 |
11-24-2013 05:31 PM Last Post: Apsogos |
|
User(s) browsing this thread: 4 Guest(s)