My 4AGE N/A build
01-14-2013, 07:31 AM
Post: #14
 
Lewy Wrote:
4000GT Wrote:A stock clutch will easily hold the power you are looking to make. I have a stock clutch with a slightly heavy duty cover on a motor making 175WHP. Good drivability.

Wish i had known that before but i now have a Toda flywheel in there with a TRD clutch cover and a Helix 4 paddle disc. Probably best to run the paddle as it will be getting drifted pretty hard so id assume the clutch would suffer pretty bad.

Had a TRD cover with std disk before, worked fine, pretty much to the very end of the clutch disks, but since then I´ve changed to a helix paddle with sprung center and its a lot better no slipping and its either on or off.
Every clutchkick a success, hardly noticed any wear and its a drift only car.
Only thing that bothers me is the pedal travel to far up, might be cause I´ve mixed TRD and Helix, but as I said the biteing point hasn´t changed since new.

1979 Toyota Corolla KE35
1983 Toyota Corolla AE86
1985 Toyota Corolla AE86
Find all posts by this user


Messages In This Thread
My 4AGE N/A build - Lewy - 08-18-2011, 02:14 AM
[] - Bean - 08-18-2011, 08:07 AM
[] - Eircamae86 - 08-18-2011, 12:50 PM
[] - Lewy - 08-18-2011, 09:56 PM
[] - Bean - 08-18-2011, 11:30 PM
[] - Lewy - 08-18-2011, 11:59 PM
[] - oldeskewltoy - 08-19-2011, 03:49 AM
[] - Lewy - 08-19-2011, 05:31 AM
[] - oldeskewltoy - 08-19-2011, 07:24 PM
[] - Lewy - 08-19-2011, 09:32 PM
[] - Lewy - 01-14-2013, 06:35 AM
[] - 4000GT - 01-14-2013, 07:03 AM
[] - Lewy - 01-14-2013, 07:14 AM
[] - fax0815 - 01-14-2013 07:31 AM
[] - Lewy - 01-14-2013, 08:58 PM
[] - Alex170984 - 01-18-2013, 03:13 PM
[] - Bean - 01-18-2013, 03:50 PM
[] - Lewy - 01-25-2013, 04:42 PM

Possibly Related Threads...
Thread Author Replies Views Last Post
  7AGE Build apardal 5 734 08-02-2024 12:11 PM
Last Post: apardal
  Build your own adjustable fuel pressure regulator ;) oldeskewltoy 8 20,840 08-19-2018 12:08 PM
Last Post: AlexKTM
  NA Build Questions | Blue-/ Redtop questions d3nso 18 16,074 02-25-2013 07:01 PM
Last Post: oldeskewltoy
  what bearings for my build? Bean 6 6,351 09-22-2012 10:25 PM
Last Post: oldeskewltoy
  Doing a 7AGE build, gasket question Snejk 9 14,107 07-15-2010 12:42 PM
Last Post: PetzK

Forum Jump:


User(s) browsing this thread: 4 Guest(s)

Contact Us | AEU86 | Return to Top | Return to Content | Lite (Archive) Mode | RSS Syndication