|
4AGE Heat Shielding Intake Gasket
|
|
03-30-2013, 04:52 PM
Post: #4
|
|||
|
|||
|
Thanks for the replies. The issue I am facing is the following: I have just installed a Blitz supercharger on my 4AGZE 7 rib block and 4AGE big port head.
After a quick test drive, my PLX gauge measured 84 degrees Celsius for intake temp for the air after the supercharger and before the intake valves. That's too much. Since the Blitz supercharger is right on the intake side of the head, there is no intercooler option. I am now setting up water injection but I need to lower intake temps without it. It starts with ambient temp (27) and keeps increasing.... I need to check there is enough oil in the supercharger as well. You can not touch the supercharger, it's too hot in my case. Jondee86: is this 1/8 of an inch thick? 1986 Toyota Corolla AE86 Levin Kouki Coupe Panda White/Black 2002 Toyota MR2/MR-S T-Sport Blue Mica |
|||
|
|
« Next Oldest | Next Newest »
|
| Messages In This Thread |
|
4AGE Heat Shielding Intake Gasket - asyrigos - 03-29-2013, 09:29 PM
[] - asyrigos - 03-30-2013 04:52 PM
[] - oldeskewltoy - 04-01-2013, 12:19 AM
|
| Possibly Related Threads... | |||||
| Thread | Author | Replies | Views | Last Post | |
| AE86 4age engine not starts crank ok backfires to air intake | Ryo | 18 | 17,042 |
08-16-2018 01:36 AM Last Post: Bean |
|
| valve tick on cylender two intake | dinkers542 | 31 | 27,838 |
12-15-2014 09:52 AM Last Post: Bean |
|
| 4age blue top from MR2 same intake manifold? | dinkers542 | 8 | 10,325 |
11-02-2014 05:24 PM Last Post: ditn |
|
| Oil leak (maybe a cylinder head gasket?) | max_ae86 | 15 | 16,886 |
11-30-2013 03:59 AM Last Post: jondee86 |
|
| My new rebuilded denso starter (Heat soaked?) | Apsogos | 8 | 7,676 |
10-01-2012 07:43 PM Last Post: Apsogos |
|
User(s) browsing this thread: 4 Guest(s)