Starter motor questions - rebuild
08-31-2013, 08:43 AM
Post: #5
 
allencr Wrote:Just put 12V to the other terminal(M in the diagram, that large terminal that goes into the starter motor) to see if it'll run. It also energizes the holding coil but it won't be strong enough to move the gear.

That's what I tried. As you say, it slides the gear out but it doesn't engage the motor. I'm guessing the connector ( B ) usually provides a stronger connection to the motor to turn it when it's not worn.

I did pull apart the motor again last night and the brushes appear to be fine. They all sit firmly with little to no wearing down. So, that galvanised connector (no matter how minor it looks) must be the culprit.
Find all posts by this user


Messages In This Thread
[] - jondee86 - 08-31-2013, 12:34 AM
[] - Jezza_hr - 08-31-2013, 01:04 AM
[] - allencr - 08-31-2013, 07:12 AM
[] - Jezza_hr - 08-31-2013 08:43 AM
[] - Apsogos - 08-31-2013, 03:05 PM

Possibly Related Threads...
Thread Author Replies Views Last Post
  20v Silvertop - New Haltech ECU & Couple of questions 20valver 10 2,266 05-26-2024 07:40 PM
Last Post: totta Crolla
  Windscreen stoopid(?) questions.... Mylesmck 7 1,062 04-30-2024 09:46 PM
Last Post: Mylesmck
  Bluetop Engine Rebuild multiple question Goal 150-160hp Hanzo 16 9,214 04-19-2021 10:08 PM
Last Post: Hanzo
  Rear Differential rebuild chenfon 10 9,193 11-20-2020 12:18 AM
Last Post: totta Crolla
  AE86 4A-GE 16v engine harness rebuild FanIsHere 7 10,005 01-17-2020 08:04 PM
Last Post: Project D

Forum Jump:


User(s) browsing this thread: 4 Guest(s)

Contact Us | AEU86 | Return to Top | Return to Content | Lite (Archive) Mode | RSS Syndication