OST-028: Redline it baby....

[oldeskewltoy]

oldeskewltoy;411742 Wrote:So with the ports nearly finished... I proceed to the chamber work. Basic, or minimum deshrouding to start....




... but more will be required...

I wasn't sure how much... after all... the clients valves were not going to be used, I had picked through my old valves for a decent set. So "new" valves, and had them ground, along with the 3 angle grind.... after all of that....

Chamber volumes were....



35cc, 35.2cc, 35.2cc, 35.1cc (based on beginning meniscus levels)

All in all not too bad, well within acceptable tolerance... but I worked #1 a bit more then the other three, I'll have finished chamber volumes by Monday...



Now here is the progression of chamber #2....




More to come..........