AEU86 : EU AE86 Community
-
AE86
-
AE86 : Technical 
-
Pistons, Clearances, Compression Ratios and Fuel
-
Pistons, Clearances, Compression Ratios and Fuel
|
Pistons, Clearances, Compression Ratios and Fuel
|
|
06-26-2007, 03:28 PM
Post: #4
|
|||
|
|||
|
Lipinhu, you should read the post again. My calculations are for 1mm head gasket. Thinner head gasket would raise the compression even more. My question is between 1 and 1.6mm.
NoHachi - NoIdea! Engine wasn't running lean. Was indeed running higher RPM. Might have ran with the ignition timing too advanced a long time ago that could have damaged the pistons. It wasn't water temperature. Oil temperature, I don't know. Anyway... what I really want to know is what compression you guys think I should run? And with which gasoline? Best regards |
|||
|
|
« Next Oldest | Next Newest »
|
| Messages In This Thread |
|
Pistons, Clearances, Compression Ratios and Fuel - apardal - 06-26-2007, 11:21 AM
[] - apardal - 06-26-2007 03:28 PM
[] - Rasteirinho - 06-26-2007, 05:35 PM
|
| Possibly Related Threads... | |||||
| Thread | Author | Replies | Views | Last Post | |
| 82mm Stock compression Pistons | apardal | 4 | 2,831 |
11-24-2021 04:26 PM Last Post: apardal |
|
| working out compression ratios | kazi | 2 | 3,581 |
07-16-2019 08:22 PM Last Post: oldeskewltoy |
|
| Trunk and fuel door cable | pack | 2 | 6,914 |
04-23-2018 11:01 PM Last Post: pack |
|
| Small Port 10.3 Pistons | Alex170984 | 1 | 4,347 |
10-25-2016 09:18 PM Last Post: oldeskewltoy |
|
| What is cranking compression on 10-1 4AGE? | oldeskewltoy | 2 | 4,739 |
03-24-2015 10:18 AM Last Post: ditn |
|
User(s) browsing this thread: 6 Guest(s)