|
Crankshaft Bearings
|
|
08-29-2007, 01:06 AM
Post: #4
|
|||
|
|||
|
Dan, from your post I get the idea that if it was you, you would keep the same crank bearings since they are a little on the loose side, but not too much (0.003mm). Is that right ?
Best regards |
|||
|
|
« Next Oldest | Next Newest »
|
| Messages In This Thread |
|
Crankshaft Bearings - apardal - 08-27-2007, 03:56 PM
[] - oldeskewltoy - 08-28-2007, 11:31 PM
[] - apardal - 08-29-2007 01:06 AM
[] - oldeskewltoy - 08-29-2007, 08:30 AM
|
| Possibly Related Threads... | |||||
| Thread | Author | Replies | Views | Last Post | |
| Crankshaft stamping | Blaze0010 | 6 | 1,303 |
06-10-2024 10:16 PM Last Post: Blaze0010 |
|
| Question on Rod Bearings | mister86 | 3 | 3,968 |
03-19-2020 03:46 AM Last Post: oldeskewltoy |
|
| Emergency help find store with bearings france | Allexz | 5 | 4,655 |
09-12-2019 03:24 PM Last Post: Allexz |
|
| Diff bearings | izanagi | 11 | 15,955 |
07-05-2014 07:29 PM Last Post: assassin10000 |
|
| Top mount bearings | totta Crolla | 1 | 3,750 |
01-22-2014 11:33 AM Last Post: totta Crolla |
|
User(s) browsing this thread: 6 Guest(s)