Mocal oil cooler & sandwitch plate ordered

[Gtsi-R]

Heey guys, Just found out since I have the oil temp sensor in, that the motor oil in my Hachi is getting a bit hot..

During normal drive at (120/130 km/h) it is 115 / 120 Dgrs Celsius.

I have no IC mounted on top of the 4agze.. it is a bend pipe!
But during normal use that should not make the difference..

I have seen that I have also got a Oil cooler mounted..

But (according to the previous owner) it is not wired on to the block and still left from before the swap!!
Normally 4agze's do not have oil coolers he says..

Is that true??

Cause I want to wire up the oil cooler for some cooling!!
But I have a small problem. If it is not common used for a 4agze to have a oil cooler.. Where do I link the oil drains to?

I have already got a adapter ring between my filter.. Are there any original attach points?

Other thing that I have seen is a oil filter relocation kit... (Greddy)

Just some loud thinking.. There is a "feed" and a drain "side" with valves ore something? Can I put one hose on the feed side of the relocator of the block, the other hose of the relocator (relocated piece) on the "in" and then a hose from the located piece back to the block on "drain"

Hope you guys understand me


so please a bit help on this one!!

cheers,

Roel