Silvertop Install, Clutch Flywheel problems, please help!!

[jondee86]

If I remember correctly, there are thrust washers on the crankshaft
to control the forward and back movement. Without reference to the
manual, I can't say the standard clearance. However, it will be quite
small, probably no more than 0.5mm.

When you say the clutch grabs... does it just give a tiny movement,
or does the car actually jump forward by some distance ?? The
release bearing that comes with a FWD clutch kit is completely
wrong for a T50 setup. Did you change the release bearing ?? Did
you install a spigot bearing in the ST flywheel ??

Cheers... jondee86