Silvertop Install, Clutch Flywheel problems, please help!!

[jondee86]

Should be fine then... no different from fitting a clutch kit to
your previous setup. For the car to move forward the clutch
must be getting some sort of contact. Maybe the high rotational
speed when disengaged, causes some small movement of the
pressure plate ? Enough to just kiss the clutch plate ??

Does your clutch take up with the pedal close to the floor, or
not until the pedal is almost at the top of its stroke ?? If it takes
up as soon as the pedal leaves the floor, you most likely have a
problem with your slave cylinder.

Cheers... jondee86