AE86 GTV-Multipoint Cage, Beams, AP Brakes & Brides

[Jan Pedersen]

jdm86gtz Wrote:

Jan Pedersen Wrote:Where do I get an air box like that for my 4AGE? It looks awesome!

http://page8.auctions.yahoo.co.jp/jp/auction/h180594989

I am looking for one with a much bigger volume to get an improvement over this:

[Conrad]

Update Time..... A few more bits and pieces but more importantly its ALIVE, it runs

Cutting out for the tailgate locks



and fitted...



Rear Quarter Window fitting











Radiator modified to sit lower, pins welded on and brackets positioned



Air / Water Separator Fabricated and fitted

---

...and here it is running on its very first start up.... (no exhaust system connected to the manifold)

Click the picture

[Bean]

sounds nice, must feel good after so long

[oldskull]

:thumbs:
Sounds great!

[krullibull]

That was a really good idea for the locks on the hatch. I might just steal that (idea ) from you.

[Conrad]

Ok here's the updates from a while ago....


Air box back plate and trumpets mounted.


Air box fitted, lid retainer clips fitted also.





Window slider, door handles, lock and window trims fitted.





Rear window trims fitted, tailgate aero catches fitted.



Hydraulic handbrake, cable handbrake setup



The pedal box needed relocating for the master cylinder clearance against the bulkhead, this was achieved by water jet cutting a plate that mounted onto the original Tilton pedal set mounts on the chassis and then allowed the Tilton pedal set to be mounted on the plate 1" further forward.



And mounted....



That's all for now folks, next up is to finish a few little odds and ends, map it on the dyno and then I will bring it home to finish off the other little stuff like sorting the hole on bulkhead, remount the chassis plate, air box intake hose and scoop, fit side skirts, fit rear bumper, fit front bumper, fit splitter and decide on final paint scheme etc

[Conrad]

Well it's mapped, 195 ATW on Dyno Dynamics, holds power to 9000 rpm then it starts to taper away towards 9400rpm.

It's a lot less than I had hoped for, it would seem something's not working well together but for now let's just get it home, MOT'd, finish a few small bits and on get it on the road, it's only been 7 years :lol:

[Uzelac]

Stock cams ?
230+ engine hp?
Sounds great if you ask me.

[Conrad]

No mate, it has Toda Cams.

[Celica RA45]

will need to look at your dyno chart