|
Crankshaft stamping
|
|
04-15-2024, 10:41 AM
Post: #4
|
|||
|
|||
|
RE: Crankshaft stamping
That's honestly good to know, considering the missing stamping on my crank.
I'll probably go with the ACL bearing, the standard one not the Race, from Flo's, plastigauge and call it a day. Being a very basic stock rebuild i'm probably worrying too much. I've measure the crank and rod journal are all 40.000, while main journal goes from 47.985 to 47.990, so according to the manual, in spec. I'll just re-check to run out to be sure, but also that seems to be all good. I might do some polishing, but honestly don't even know if it's worth it! |
|||
|
|
« Next Oldest | Next Newest »
|
| Messages In This Thread |
|
Crankshaft stamping - Blaze0010 - 04-11-2024, 02:40 PM
RE: Crankshaft stamping - Ivan141 - 04-12-2024, 08:13 AM
RE: Crankshaft stamping - The Doctor - 04-13-2024, 08:44 AM
RE: Crankshaft stamping - Blaze0010 - 04-15-2024 10:41 AM
RE: Crankshaft stamping - oldeskewltoy - 04-19-2024, 06:41 PM
RE: Crankshaft stamping - Blaze0010 - 04-24-2024, 05:39 PM
RE: Crankshaft stamping - Blaze0010 - 06-10-2024, 10:16 PM
|
| Possibly Related Threads... | |||||
| Thread | Author | Replies | Views | Last Post | |
| Which new bearings for ae101 4AGZE crankshaft&connecting | ditn | 4 | 7,113 |
10-31-2013 06:04 PM Last Post: ditn |
|
| crankshaft timing belt pulley won't come off | Dino86 | 8 | 9,391 |
02-21-2011 02:05 PM Last Post: Project D |
|
| Crankshaft Pulley Bolt ?? | juantonwan | 3 | 6,228 |
03-05-2010 10:55 PM Last Post: Mikzu IV |
|
| about Crankshaft again | filh | 2 | 5,109 |
12-20-2008 11:53 PM Last Post: filh |
|
| 2a engine crankshaft | c.acton1 | 2 | 3,958 |
09-03-2008 05:37 AM Last Post: F0Bman |
|
User(s) browsing this thread: 10 Guest(s)