Filters for ITB BT 20V

[gjuro]

I need to buy some filters for my Blackie. Do you have any experiences with pipercross, kn, or some other brands?

Where did you buy them, and what is the price?

[assassin10000]

Instead of doing individual filters, maybe do the complete cover from ITG filters or Jenvey.

They work well (better than individual socks/k&n's) as they allow room for airflow to enter the stacks/bellmouths sideways, and can look awesome.

ITG - http://itgfilters.net


On a blacktop 20v, borrowed from here:
http://www.dorikaze.net/showthread.php?t=21271



Jenvey - http://www.jenvey.co.uk/


Andrew

[isac]

1 x BASE PLATE BLANK ALLOY (ITG-9JC40)
1 x ITG FILTER JC40-100 (ITG-JC40-100) or ITG-JC40-65
1 x ITG FILTER DUST SPRAY (ITG-JDR1)


"

Fitting advice

Selection of the filter element depends on the amount of
room available.
ITG recommend fitting the tallest element possible, though
a gap of 1/2” (13mm) average must be left over the top of
the filter for air to circulate.
If using ram pipes, there must be an absolute minimum gap
of 3/4” (19mm) or preferably 11/4” (32mm) between the end
of the pipe and the underside
of the top of the filter.

"

[Lajoosh]

BUMP!

any other ideas? i need an easy and preferably unexpensive solution.
uni sock filters maybe? experiences?

[boo50]

the filter is not very expensive.
http://www.isa-racing.com/product_info.p...ement.html

ITG sell base plate w/o holes
but I'm preffer laser cut plate.
does anyone have a drawings of plate for 20v BT?

http://www.isa-racing.com/product_info.p...latte.html

[[Walaki]D`Lair]

I have the Pipercross filter, and its easy to use and easy to clean...

[Akis308]

I've used uni socks (the light-green ones).
When I had them on I've noticed a very big responce and power loss...
When you are using filter on velocity stack you must have a very large area...