|
Half Shafts Poblem
|
|
04-17-2018, 01:04 PM
Post: #4
|
|||
|
|||
|
RE: Half Shafts Poblem
I would agree with Ivan141. Removing the axle shaft will require a BIG slide hammer. One side of my axle housing had so much rust, that I had to heat it with a torch to pull it out. Which means you will have to buy a new bearing. I found the same OEM mfgr of the bearing, but at less then 50% of the Toyota cost on-line. Dave W
|
|||
|
|
« Next Oldest | Next Newest »
|
| Messages In This Thread |
|
Half Shafts Poblem - AlexKTM - 04-16-2018, 06:37 PM
RE: Half Shafts Poblem - jondee86 - 04-17-2018, 04:17 AM
RE: Half Shafts Poblem - AlexKTM - 04-22-2018, 03:13 AM
RE: Half Shafts Poblem - Ivan141 - 04-17-2018, 09:08 AM
RE: Half Shafts Poblem - Dave W - 04-17-2018 01:04 PM
RE: Half Shafts Poblem - Ivan141 - 04-23-2018, 08:48 AM
RE: Half Shafts Poblem - MIGGZFSU - 04-23-2018, 04:42 PM
|
| Possibly Related Threads... | |||||
| Thread | Author | Replies | Views | Last Post | |
| How to fit rear wheel studs without removing the shafts? | Slipangle | 3 | 4,877 |
11-19-2010 10:29 PM Last Post: Slipangle |
|
| problem again , about leaking half shaft bearing | filh | 10 | 10,081 |
03-22-2009 01:03 AM Last Post: filh |
|
| rear axle half sharft | ToFu Ben | 13 | 11,279 |
09-27-2008 02:02 AM Last Post: sergiocharged |
|
| Rear Half Shaft axles | Strobelite | 13 | 12,546 |
12-07-2007 12:05 AM Last Post: Strobelite |
|
| Half shaft problem | Mr Doricar | 3 | 4,547 |
11-06-2006 11:36 AM Last Post: jamiemirror |
|
User(s) browsing this thread: 2 Guest(s)