Some engine, brake and suspension DIY components.

[jamiemirror]

Sorry to skip the dollar sign ($) before 180.
The prices are in USD, there can be minor changes (up to 10EU) just for anodising (with/without colouring). Already built the 25mm set, cost was 150EU anodised (maybe USD/EUR ratio was little different while ago too, didn't record it).

[Bubble_Drift]

Interested in some 25mm and 15mm spacers.
And a set RCA's.
How fast could you make them?
Thanks!

[jamiemirror]

25mm and 15mm spacers - that means spacers 4X114mm PCD without studs etc. - correct ?

[Bubble_Drift]

Yes 4x114,3 for the hachi.
I was actually after the bolt on type.
Like these:

[Apolan]

jea how much would be those in 25mm?

[jamiemirror]

Bubble_Drift, on your picture I see wheel adapters (not spacers) - these cannot be produced with 15mm thickness. Spacers need longer studs, adapters use their own studs. Unfortunately stock AE86 studs will work with very thin adapters - ~5-6mm thickness.

[Apolan]

wow talk about coincidences!!! Some guy who spent the past two years or so improoving his Fiat Coupe 2.0 turbo, just crashed it on his maiden voyage..

Reason: broken off adapter - 4 to 5 lugs. the adapter spacer was 20mm, but he thinned it to 13mm so he wouldnt have clearance problems.. spacer broke off at 130kph in fast corner..



what a shame.. something you pour your heart into... hope this never happens to any of you people..

so the adapter was either to thin or there was some casting fault / imperfections in the material.. i guess go with 25mms...

[Bubble_Drift]

jamiemirror Wrote:Bubble_Drift, on your picture I see wheel adapters (not spacers) - these cannot be produced with 15mm thickness. Spacers need longer studs, adapters use their own studs. Unfortunately stock AE86 studs will work with very thin adapters - ~5-6mm thickness.

Aha.. I see.
Well, how much for a set of 4x 25mm adapters and a pair of RCA's then?
Do you make adjustable panrods btw?

[jamiemirror]

Set (4) adapters $180 (~138EU) including screws and pressed studs.
RCA (pair) 40EU including bolts.
No, I just modify stock panhard rod using ready set of components (for example you can see CJ's project, he made modification himself using the same bolt&screws "kit"). In fact maybe adj. rod and 4-link rear arms will be reasonable to manufacture - I will think about that

[broken_tofu]

what about some NCRA or strut rods(caster rods)?