Water Temperature Instrument not moving - Sender Gauge
12-06-2017, 03:34 PM
Post: #7
RE: Water Temperature Instrument not moving - Sender Gauge
(12-06-2017 01:41 PM)Hama86 Wrote:  
(12-06-2017 10:30 AM)d3nso Wrote:  Isolation against heat isn't needed a quick wrap with electrical tape does the job if your're paranoid
That is my problem: paranoia.

I fixed the connector, the gauge is moving up.

Now I have to figure out why I have white smoke on idle at traffic lights.
If they rebuilt the engine some smoke is expected but should diminish after a while. Also factor in the current outside temperatures/condensation.
Do you have white smoke at idle when the engine has properly warmed up in warm garage at idle

AE86 ex-daily
Visit this user's website Find all posts by this user


Messages In This Thread
RE: Water Temperature Instrument not moving - Sender Gauge - Bean - 12-06-2017 03:34 PM

Possibly Related Threads...
Thread Author Replies Views Last Post
  EUDM gauge cluster banpei 22 4,339 08-15-2023 10:48 PM
Last Post: banpei
  20v conversion water relocation izanagi 1 5,414 06-15-2016 09:45 AM
Last Post: banpei
  Analog gauge cluster tech Ivan141 33 41,941 01-31-2016 11:06 PM
Last Post: Bean
  WTF is that? speedodrive sender adaptor thingy.... fax0815 8 12,046 09-14-2015 12:16 PM
Last Post: pack
  Original gauge with universal fuel sender Komba 4 6,274 01-05-2015 03:27 PM
Last Post: Komba

Forum Jump:


User(s) browsing this thread: 2 Guest(s)

Contact Us | AEU86 | Return to Top | Return to Content | Lite (Archive) Mode | RSS Syndication