Megasquirt I v3.0 and toyota distributor/igniter

[Morten]

Chrisso Wrote:I'm pretty sure the 2.89 code clears up the VR signal spikes are higher rpms. There's a post giving details in the ms general forum. msefi.com

Mines set up with as above, but I'm having serious comm issues and my trigger +/- is giving me the shits, rejecting ignition events.

Not sure if you mean the above as in the pics I posted with teeth removed, but if so be sure that you have removed the tooth all the way down to the base and not only the tip. A friend of mine did that mistake on a 1uzfte and had all kinds of trouble

[Chrisso]

Thanks morten. Yes, I did mean the same as your set up. My issue was a communication error between the MS and the laptop from using a USB to Serial adaptor. I've since swapped laptops and am using a proper serial port. All errors are gone, cranking RPM is rock steady at ~230 and everything else checks out. Hopefully have it running on the weekend.

[Chrisso]

Engine start up but require alot of enrichments + throttle. So, if anyone has a VE table & spark advance they'd like to share it would be much appreciated! It would be nice to get a good idle and get it running well.