|
Oil Leakage from Head (near distributer)
|
|
09-10-2011, 10:09 AM
Post: #2
|
|||
|
|||
|
Oil level dipstick getting blown out of holder...
If the oil level gauge (= dipstick) is being forced out of its holder, it is
usually because there is excessive crankcase pressure inside the engine. The pressure is caused by "blowby" of combustion gases past the piston rings. The amount of blowby increases at high rpm's. Check that your cam cover vent is not blocked. You may need to fit an extra vent (two intake side cam covers) and run the tubes to a "catchcan". Cheers... jondee86 |
|||
|
|
« Next Oldest | Next Newest »
|
| Messages In This Thread |
|
Oil Leakage from Head (near distributer) - chenfon - 09-10-2011, 04:59 AM
Oil level dipstick getting blown out of holder... - jondee86 - 09-10-2011 10:09 AM
Mystery oil plug... - jondee86 - 09-12-2011, 06:12 AM
[] - ash16valve - 09-17-2011, 12:54 PM
[] - ash16valve - 09-21-2011, 10:56 PM
|
| Possibly Related Threads... | |||||
| Thread | Author | Replies | Views | Last Post | |
| trans oil, lsd oil change | Apolan | 9 | 17,068 |
10-01-2014 03:57 PM Last Post: mad.matt |
|
| Oil leak (maybe a cylinder head gasket?) | max_ae86 | 15 | 17,174 |
11-30-2013 03:59 AM Last Post: jondee86 |
|
| Oil cooler -> low oil pressure | Jan Pedersen | 24 | 30,598 |
06-06-2013 07:36 PM Last Post: Deuce Cam |
|
| 4AGE crankcase gas and oil pressure too high, sprinking oil | demogun | 5 | 7,774 |
10-01-2011 09:47 AM Last Post: demogun |
|
| Weber 45's & starlet distributer info | megabob | 8 | 8,823 |
07-12-2011 02:46 PM Last Post: megabob |
|
User(s) browsing this thread: 16 Guest(s)