Small port 16v with F/A internals

[oldeskewltoy]

I was wondering what ever happened to your rods and pistons??? Glad to see you are using them.




11.5 to 1 with 280 cams is a touch low.... if you find you could use a bit more, you can likely take a 1/2mm(.020") cut from the head......

http://www.catcams.be/800x600/prod01Alis...71051xx.js - 16V cams

Cat doesn't seem to show a 280/9mm, do yours have any identifying marks??


If you click on the part numbers, the timing specs pop up... you might try using the timing specs to see if you really have 280/9mm cams.

Finally, if you are sure they are 280 and 9mm, you could send cat cams a request, show them the identifying marks and let them get you further info(timing info)

Good luck with it... and I would very much like to see a dyno print out when you are finished