Fitting driftworks CS2 coilovers

[bozu]

Hi guys,

I'm in the process of fitting Driftworks CS2 coilovers to my AE86 and was wondering if someone on this forum has done this before as I have some questions.

My questions are:
- I cannot get the front outer wheel bearing to slide over the spindle as it does on the OEM set-up. It would need to be pressed on with a hydraulic press in order to fit but I can not imagine this is correct. Has anyone experienced this as well?
- The bottom mounting point of the rear shocks seems to be wider than the pin on the rear axle it slides onto. Therefore the bush is not fully supported. Is this a problem?
- Do I need the OEM rubber and steel washers to mount the top of the rear shocks? I'm currently running aftermarket shocks and their rubber and steel washer do not fit the CS2's. If I need the OEM parts does anyone has them for sale?

I've also contacted Driftworks on the above but no response yet.

Cheers,

Bozu