about 5mm TRD headgasket

Threaded Mode | Linear Mode

about 5mm TRD headgasket

04-07-2007, 03:28 AM

Post: #20

apardal Offline

Senior Member

Posts: 512
Joined: Jan 2005
Reputation: 0

I would guess you might get away with that kind of shaving + metal head gasket.

A nice bottom end power would be defenately gained. But the raise in compression might wear those conrod bearings a little bit more.

Best regards

« Next Oldest | Next Newest »

Messages In This Thread

about 5mm TRD headgasket - filh - 12-08-2006, 01:10 AM

[] - jamiemirror - 12-08-2006, 10:32 AM

[] - Denmark - 12-08-2006, 12:28 PM

[] - apardal - 12-08-2006, 02:21 PM

[] - meshin - 12-08-2006, 11:58 PM

[] - filh - 12-09-2006, 12:20 AM

[] - ZDoman - 12-09-2006, 12:33 AM

[] - Hoey - 12-09-2006, 09:18 PM

[] - Hoey - 12-10-2006, 11:02 PM

[] - apardal - 12-11-2006, 11:02 AM

[] - jamiemirror - 12-11-2006, 01:24 PM

[] - Hoey - 12-12-2006, 04:25 AM

[] - jamiemirror - 12-12-2006, 10:42 AM

[] - Rasteirinho - 04-04-2007, 07:49 PM

[] - Apolan - 04-04-2007, 08:43 PM

[] - Rasteirinho - 04-04-2007, 10:57 PM

[] - gon - 04-05-2007, 12:52 AM

[] - Apolan - 04-05-2007, 09:59 AM

[] - gon - 04-05-2007, 11:00 AM

[] - apardal - 04-07-2007 03:28 AM

[] - Rasteirinho - 04-07-2007, 03:35 PM

[] - gon - 04-13-2007, 01:07 PM

[] - Apolan - 04-13-2007, 07:03 PM

[] - jamiemirror - 04-13-2007, 08:25 PM

Possibly Related Threads...
Thread		Author	Replies	Views	Last Post
	Silvertop Headgasket?	byd1380	3	3,977	01-05-2009 06:02 PM Last Post: byd1380
	9.5mm lift camshafts with OEM followers... anyone?	apardal	9	8,941	10-15-2008 03:24 PM Last Post: robokill
	head skiming/size headgasket/hks f-con!	nick	9	8,120	04-10-2008 06:17 PM Last Post: oldeskewltoy
	will the 0.5 mm HEADGASKET clear?	Apolan	15	12,795	01-31-2008 01:48 PM Last Post: meshin
	5mm headgasket	filh	14	10,956	01-28-2007 08:29 AM Last Post: Plex

User(s) browsing this thread: 6 Guest(s)