Engine/Drivetrain Vibration Issues
|
09-09-2007, 02:21 PM
Post: #15
|
|||
|
|||
The rattling is heard on all gears.
About the fuel cut, my AFR only measures between 10 and 16, above 16 it will show "Air", and that's what I read on decelerating off throttle. Yesterday I went to a friend mechanic and he jacked my right rear wheel and asked me to gear the car and start rolling until I reach 3000 rpm to listen underneath the car. We could hear the rattling but couldn't really say where it came from. He told me it might be unbalanced flywheel, but he gave me a good way to find out. He told me to disconnect the driveshaft (after the center bearing) and start the engine throughout the gears to look for rattles. If there are none, it most likely comes from the rear end. If there are, then it can come from the flywheel or the crank bearings that I installed wrong. Best regards |
|||
« Next Oldest | Next Newest »
|
Messages In This Thread |
Engine/Drivetrain Vibration Issues - apardal - 09-06-2007, 09:54 PM
Shake, rattle and roll :-| - jondee86 - 09-07-2007, 08:03 AM
[] - dikolotour - 09-07-2007, 12:05 PM
Ghosts in the gearbox... - jondee86 - 09-07-2007, 02:12 PM
First, define the problem.... - jondee86 - 09-08-2007, 12:44 AM
What did you change ?? - jondee86 - 09-08-2007, 01:26 AM
Fuel saving... - jondee86 - 09-09-2007, 02:45 AM
[] - apardal - 09-09-2007 02:21 PM
[] - Rasteirinho - 09-14-2007, 01:10 AM
Launch control.... - jondee86 - 09-14-2007, 03:12 AM
|
Possibly Related Threads... | |||||
Thread | Author | Replies | Views | Last Post | |
Running issues | sam3007 | 6 | 2,732 |
06-26-2022 01:34 PM Last Post: Dave W |
|
Over heating issues | MIGGZFSU | 12 | 11,350 |
05-11-2017 05:09 PM Last Post: MIGGZFSU |
|
Shortshifter TRD - Issues | pack | 13 | 12,546 |
09-19-2016 10:57 PM Last Post: jondee86 |
|
Decently heavy vibration in fourth gear between 2000-2300rpm | dinkers542 | 4 | 5,479 |
11-29-2014 12:27 AM Last Post: dinkers542 |
|
20v Starting Issues | mad.matt | 10 | 11,588 |
09-24-2014 12:44 PM Last Post: pack |
User(s) browsing this thread: 2 Guest(s)