|
Rear Traction Brackets DIY? Dimensions ?
|
|
04-15-2010, 11:52 PM
Post: #2
|
|||
|
|||
|
Most brackets have the same layout for the upper part, as the axle brackets all have the holes in the same place. It's the lower your going to have to determine... I think 'most' put it about 50mm below the stock point. You can do more or less depending on how lowered you are.
|
|||
|
|
« Next Oldest | Next Newest »
|
| Messages In This Thread |
|
Rear Traction Brackets DIY? Dimensions ? - Uzelac - 04-13-2010, 09:48 AM
[] - assassin10000 - 04-15-2010 11:52 PM
|
| Possibly Related Threads... | |||||
| Thread | Author | Replies | Views | Last Post | |
| DIY: a quick outline on why & how to set pinion angle. | assassin10000 | 9 | 18,085 |
12-21-2016 10:28 PM Last Post: ditn |
|
| Quick question - Brake Pad Dimensions | Lt86 | 2 | 5,252 |
06-07-2015 12:08 AM Last Post: jondee86 |
|
| Dimensions clutch master cylinder | bozu | 2 | 6,028 |
04-16-2015 07:11 AM Last Post: bozu |
|
| 4 Link setup and Traction brackets | Jezza_hr | 5 | 9,964 |
07-21-2014 09:12 PM Last Post: Bean |
|
| Spindle dimensions, backing plate bolt pattern | Rascal21 | 18 | 21,228 |
03-13-2014 11:45 AM Last Post: Rascal21 |
|
User(s) browsing this thread: 4 Guest(s)