TRD Damper inserts in front struts

[Dino86]

fax0815 Wrote:Have you checked that there are no spacers, rust and other sh** inside the struthousing (under the insert)? I had washers there, rusted to the housing. Hard to see and hard to get out...
If I look at your pics, its a difference nut.
Mine had a different seat for the insert (camfered inside and little camfer on outside) and I I think it was shorter (not so much material after the thread) but could be mistaking...

I´d get it on a lathe and make it fit.
Or you can try Toyota and buy the nut from AE92, cause thats what I think was used by the previous owner...

Maybe this helps a little?

Thanks for your help.
Inside of the strut looks OK: No rust etc. Struts were equiped with OEM inserts (gas filled) before dismantel, so the nut should be OE AE86.
I'll check for AE92 nut. If not, I'll make it fit...